MintyPi V3 PCB Kit Pre-Order

mintyPi V3 Pre-Order Kit

$90.00 price_excluding_tax

Out of stock - Join the waitlist to be emailed when this product becomes available

Pre-Orders will run from July 8th till August 4th.

After this time frame I will put the order into the pcb maker and I expect the kits in Mid October but I will post any updates on the dates if they change.

I suggest ordering a battery with the kit in the same order as I will not combine orders if you make separate orders.

Separate orders in the past have caused nothing but confusion,headaches and money and time lost which I want to avoid. Thanks for your support.

Check your PayPal shipping addresses BEFORE you order a kit, I will no longer make changes for people and just cancel your order. If you can no longer make a repurchase after I cancel such an order I will not accommodate you, please check your shipping info to avoid headaches on both sides

NOTE: mintyPi Logo is no longer present on the bootup as is shown in video above.

The kit includes the following :

  1. Controller PCB
  2. FPC Ribbon (to connect LCD board to the Controller PCB)
  3. LCD PCB with the 2.6inch LCD soldered onto it
  4. Power Board with Battery Connector and L/R board solder points
  5. Headphone Socket (unsoldered so it’s an option to add to the build)
  6. Wiring Harness (connects Power Board & L/R board to Controller PCB)
  7. Speaker to be soldered by 2 wires (WIRES not included in KIT) to the Controller PCB

Suggested to use 5V phone chargers for the mintyPi along with a USB-C cable or one of the 3in1 cables I offer on my site! 9V USB-C chargers should be compatible with the new preorder kits (July 8th Pre-Order).

There is the optional battery for the build which for the time being will be sold to Mexico, Canada and USA customers only. There reason for this is the extra customs paper work and cost in shipping them out (I didn’t make the laws but must abide by them).

Not Included are the 3D parts or the Custom Silicone buttons specifically made for the mintyPi V3. These can be bought from Wermy from Sudomod below:

DISCLAIMER!!: Since this is a DIY project with alot of soldering involved I am not responsible for repairing or replacing parts you damage in the attempt of soldering the Pi to the PCBs I am offering in this kit. If it’s not pictured here then it is not included.

Please consider getting the mintyPi practice boards before attempting this project so there will no damaged boards in your assembly as I will not have extras to replace them.

Get them here from (you need both sets):

Weight 0.3 lbs