These are for the mintyPi Lite NOT the mintyPi V3.5 which gets some different cuts and is not currently available.
All Lite Tins will have the SD Card Slot cut and also the L2 and R2 holes which are now standard in the current mintyPi Lite kits.
These Tins are cut with a laser and are sometimes used tins so be aware there might be some burn marks around the holes (very minor) and the tins might be a little scuffed or might have some rust spots (internally and will be covered by 3D parts so will not be seen).
If these minor blemishes are a concern for you then do not buy them as I will not swap them for another one that might not have some of the mentioned cosmetic possible problems. I do my best to send out the best tins I have but sometimes there are minor blemishes on the inside which are likely not going to be seen with the 3D parts installed.
There are no reviews yet.